Vantec 6-Port SATA II 150 PCI Host Card w/RAID User Manual download pdf (Page 5)

UGT-ST310R Page 5

Note: There are six SATA ports in 6-Port SATA II 150 PCI Host

Card w/RAID. We name these ports from A through F. Ports A to

D are internal SATA ports. Ports E and F are external SATA ports.

Changing the jumper settings allows you to select between

external and internal ports to use. By default, Port A, B, C and D

are working.

Hardware Installation

1. Turn Off the power to your computer and any other

connected peripheral devices.

2. Unplug the power cord form the back of the computer.

3. Remove your computer’s cover.

4. Remove the slot bracket from an available PCI slot.

5. To install the card, carefully align the card’s bus connector

with the selected PCI slot on the motherboard. Push the

board down firmly, but gently, until it is well seated.

6. Replace the slot bracket’s holding screw to secure the card.

Device Connection

The 6-Port SATA II 150 PCI Host Card w/RAID is a four channel

Serial ATA controller that supports up to four Serial ATA hard disk

drives. It is recommended to use identical hard drives for all

RAID configurations.

1. Install your hard disk drive(s) in chassis.

2. Connect the Serial ATA hard disk drive to the system power

supply using the included Serial ATA power cable.

3. Connect one end of the Serial ATA cable to the hard disk

1 2 3 4 5 6 7 8 9 10 ... 19 20

No comments

Vantec 6-Port SATA II 150 PCI Host Card w/RAID User Manual Page 5