Vantec UGT-IS100R User Manual download pdf (Page 12)



UGT-IS100R Page12

connection information, will be written to the replacement disk.

Rebuild Mirror Drive

When a failure to one member occurs, you will be notified by the

RAID BIOS during boot. The steps below will guide you in

rebuilding a failed mirror set.

1. Replace the failed drive(s) with one of equal or greater

capacity, start the computer.

2. During boot press Ctrl+J to enter the RAID BIOS.

3. Select Rebuild Mirror Drive press Enter.

4. Please use arrow keys ↑ and ↓to select the array you want to

rebuild, press Enter.

5. Please use arrow keys ↑ and ↓to select the destination disk,

press Enter.

6. When rebuilding is finished, select Save And Exit Setup,

press Enter. When asked Save to disk &Exit (Y/N)?, press

Y to exit the BIOS.

BIOS Configuration

The 4+1 SATA II 300 IDE/PATA PCI-E Combo Host Card w/ RAID

& Port Multiplier BIOS will appear every time your system starts

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 21 22

No comments

Vantec UGT-IS100R User Manual Page 12